







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Hurst, TX: What the Job Actually Involves
Door installation in Hurst, TX typically runs $850 to $3,200 per opening depending on the door type, the condition of the existing frame, and whether anything structural has to move. An interior door swap is usually a one-day job; an exterior entry system with new framing, weathersealing, and finish work runs two to three days for our crews. Call (855) 912-5373 and we’ll walk you through what your particular opening will need before anyone shows up with a truck.
Our Door Installation Process, Step by Step

Most people don’t realize how much of a door job happens before the door goes in. Here’s how we run it, whether you’re replacing a builder-grade slab in a 1970s ranch off Norwood Drive or upgrading the front entry on one of the two-story traditionals near Hurst Hills.
Stage 1: On-site measurement and door selection
We measure the rough opening, check that the frame is plumb, level, and square, and note any rot, settling, or past water damage before we quote. This takes 45 minutes to an hour. You’ll decide the door style, material, and hardware at this visit, or within the week once you’ve seen samples. Hurst’s expansive clay soil means a lot of frames are slightly out of square, so we plan for shimming and sometimes reframing before the order goes in.
Stage 2: Ordering and lead time
Stock doors arrive in three to seven days. Custom-size doors, specialty glass, and premium entry systems from Andersen or Pella run three to six weeks. You’ll get a firm date rather than a “sometime next month” answer. We confirm the door slab matches the opening dimensions at order, not on install day.
Stage 3: Demo and prep
On install day we pull the old door and trim, inspect the framing for rot or insect damage, and repair anything the old door was hiding. This is where surprises show up on older Hurst homes: soft sill plates, rusted thresholds, or framing that was never flashed correctly. Prep takes two to four hours. If we find structural rot, we stop, document it, and give you a written change before proceeding.
Stage 4: Setting and sealing the door
The new door goes in, gets shimmed and squared, secured with the correct fasteners, and sealed with foam and flashing tape against North Texas wind-driven rain. Weatherstripping and thresholds are installed and tested. Entry doors take four to six hours to set correctly. We test the swing, the latch, and the deadbolt alignment before the trim goes back on.
Stage 5: Trim, finish, and walkthrough
We reinstall or replace interior and exterior trim, patch and paint what’s needed, and walk the door with you to confirm the swing, seal, and hardware all work. That walkthrough takes 20 minutes and is when we hand over the 730-Day Done Right Promise in writing. If anything’s off in the first two years, we come back and make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Options You’ll Choose Between in Hurst
The material and configuration choices move both the price and how long the door lasts in this climate. Here’s the honest read on each.
- Fiberglass entry doors: $1,200 to $3,200 installed. They hold up against North Texas heat, humidity swings, and hail better than most materials and won’t warp or split. Best for the shaded, sun-baked exposures common on west-facing Hurst lots. The trade-off is that they can crack under direct impact, though repairs are affordable.
- Steel entry doors: $900 to $2,400 installed. Strong, secure, and the most popular choice for front entries on ranch homes. They dent under impact and can rust at the bottom edge if the threshold isn’t flashed right, so installation quality matters more than the door itself.
- Solid wood and wood-composite doors: $1,500 to $4,000 installed. Beautiful and repairable, but wood in Hurst wants annual sealing against sun and seasonal swelling. Realistic for covered entries; less so for an exposed west wall.
- Interior doors: $350 to $900 per opening installed. Hollow-core is fine for closets and secondary rooms; solid-core is worth the upgrade for bedrooms and bathrooms where noise and durability matter.
- Glass and specialty configurations: $1,800 to $4,500 installed. Sidelights, transoms, and decorative glass add curb appeal and light. Custom sizes and historical profiles run toward the high end and add lead time.
Our brand partners across windows and doors include Andersen and Pella for premium systems. We’ll show you the trade-offs and let you pick, not steer you toward what’s easiest to stock.
What Door Installation Costs in Hurst, TX

A single interior door lands between $350 and $900 installed. A standard exterior entry door with new framing, flashing, and trim runs $900 to $2,400 for steel, $1,200 to $3,200 for fiberglass, and $1,500 to $4,000 for solid wood. A whole-home door package or a multi-opening job can stretch to $8,000 or more. The four variables that push a job toward the high end:
- Existing frame condition: sound framing is a fast job; rot, settling, or missing flashing adds prep hours and sometimes structural repair.
- Door material and grade: fiberglass and custom wood cost more than steel; decorative glass and sidelights add 30 to 60 percent over a plain slab.
- Relocating or resizing the opening: moving a doorway means header work, drywall, electrical for switches, and a permit, which pushes cost up substantially.
- Hurst permit scope: like-for-like swaps typically don’t require a permit; structural changes, new openings, and some HOA-regulated exterior changes do. We pull the permits and handle the inspection.
Every written estimate is line-itemed: door, hardware, trim, labor, disposal, and permit costs are all separate. No-hassle upfront pricing means the number you see is the number you pay. If a hidden condition shows up mid-job, you get a written change before we touch it. Call (855) 912-5373 for a free estimate, and ask about 0% financing for 18 months or $1,000 off projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterWhat Hurst’s Housing Stock Does to a Door Job
Hurst is mostly built out, and most of the work here is remodel and replacement on 1960s through 1980s brick-veneer ranches and small two-story traditionals on tight subdivision lots. That era of home means we’re often working around settling frames, original hollow-core interior doors, and entry doors that were never flashed correctly to begin with. On older ranch lots the mature pecan and oak canopies shade the exterior wall, which slows the sun damage on some walls but traps moisture on others, so we inspect for hidden rot before ordering.
Expansive clay soil is the other factor. Slabs move seasonally across ZIP codes 76053 and 76054, and when they do, door frames rack out of square. You’ll notice the symptom as doors that stick in summer and swing free in winter. Sometimes the fix is a rehang or a hinge adjustment; sometimes the slab issue needs to be addressed before a new door makes sense, which is why we flag it during the measurement walkthrough. When a door job is part of a full Windows & Doors in Hurst upgrade, or paired with a kitchen or entry refresh, homeowners often add Cabinets & Countertops in Hurst, and we cover all of it through our Windows & Doors service across Hurst and the surrounding Mid-Cities. If you’re converting that attached garage into living space instead, Garage Conversion ADU in Hurst pairs naturally with door and entry work.
Serving Hurst, TX – Our Local Coverage Area
We serve Hurst and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Door Installation in Hurst

A single interior door takes two to four hours; a single exterior entry door takes one to two days including framing, flashing, and trim. Whole-home packages or multi-door replacements run three to five days on site. Lead time on stock doors is three to seven days; custom doors run three to six weeks. Call (855) 912-5373 for a timeline on your specific openings.
Like-for-like door replacements generally don’t require a permit, but new openings, resizing, or header changes do. We check the scope against Hurst’s inspection requirements before work starts and pull whatever’s needed. If a permit is required, we handle the application and inspection. Call (855) 912-5373 and we’ll tell you upfront whether your job triggers one.
Yes, in most cases. A straight replacement reuses the existing opening and touches nothing behind the drywall. Moving a doorway or adding a new one means header work and sometimes electrical for switches. We flag that at the measurement stage so there are no mid-job surprises. Call (855) 912-5373 to schedule a free estimate.
Interior doors run $350 to $900 installed. Exterior entries run $900 to $4,000 depending on material, with fiberglass at $1,200 to $3,200 and solid wood at $1,500 to $4,000. Glass, sidelights, and resizing push toward the top. Every quote is line-itemed and fixed. Call (855) 912-5373 for an exact figure – estimates are free.
All our door work carries the 730-Day Done Right Promise: if it’s not done right, we make it right, for two full years after the final walkthrough. That covers labor and workmanship. Manufacturer warranties on the door itself vary by brand. Call (855) 912-5373 for details on your specific door selection.
Get a Free Estimate on Your Door Installation
Whether it’s one sticking bedroom door or every entry on a ranch home in Hurst, we start with a free on-site estimate. You’ll get a written, line-itemed quote with a firm number and a realistic timeline. Call (855) 912-5373 and a live person picks up – any hour, any day. We’ll book a measurement visit, talk through your door options, and hand you the price in writing before anything is ordered.
Written by the team at Groundwork Construction Co.












