







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Forest Hill, TX: What It Costs and How Long It Takes
A chain link fence in Forest Hill, TX typically runs $3,500 to $9,000 installed, and most residential jobs are finished in one to three days once we’re on site. The number moves with linear footage, height, gate count, and how much old fence and root work we have to clear on your lot. Call (855) 912-5373 for a free on-site estimate, and you’ll get a written, line-item number before anyone digs a hole.
How a Chain Link Fence Goes In, Start to Finish

Chain link is one of the few exterior projects where the sequence actually matters. Posts set wrong show up two summers later as sagging top rail. Here’s the order we work in, and what you decide at each step.
Stage 1 – Site walk and layout (day 1, about an hour). We walk the property line with you, confirm where the fence runs, and mark every gate opening. You’ll want to know exactly where your plat line sits before this conversation, because Forest Hill lots are tight and a fence set six inches off the line is a fence you may end up moving. You decide gate placement and swing direction here.
Stage 2 – Call 811 and clear the line (day 1, before digging). We arrange utility locates so no one drives a post through an irrigation line or a buried service. On older Forest Hill lots with mature trees, this is also when we decide how to route around root systems rather than through them. You decide whether you want us to remove low limbs that block the fence line or work around them.
Stage 3 – Demo and post setting (day 1 into day 2). Old fence comes out and hauls off. Posts go in concrete at the spacing and depth the wind load calls for, and they cure overnight. You don’t decide anything here except where the dumpster or debris pile lives, which on a narrow street matters.
Stage 4 – Framing, fabric, and gates (day 2 into day 3). Top rail, tension bands, mesh stretched and tied, then gates hung with proper hardware and a latch that closes clean. You decide gate hardware grade now, not later, because swapping a fork latch for a self-closing hinge after the fact is a second trip.
Stage 5 – Walkthrough and cleanup (end of day 3). We pull the stakes, rake the disturbance, and walk the whole run with you. Anything that doesn’t tension right gets corrected on the spot, which is what our 730-Day Done Right Promise is written for. If it’s not done right, we make it right.
Larger perimeter jobs along the 76119 side can stretch to four or five days if there’s significant demo, stump work, or a long stretch with multiple gates.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Chain link isn’t one product. What you pick drives both the price and how the fence looks in year ten.
- Gauge of mesh. 11.5-gauge is the lighter residential standard and costs less. 9-gauge is heavier, holds its shape against a dog leaning on it, and runs a few dollars more per foot. If pets or kids are the reason for the fence, go 9-gauge.
- Coating. Galvanized mesh is the budget option and rusts first in North Texas heat and summer storms. Vinyl-coated (black or green) looks sharper against a lawn and lasts noticeably longer. The color is baked on, so a scuff stays a scuff.
- Height. 4-foot reads as a boundary marker. 5-foot is the residential workhorse. 6-foot is what most homeowners pick when privacy or pet containment is the point. Each step up adds cost per foot.
- Posts and rail. Round galvanized posts are standard. Heavier wall thickness matters on corner and terminal posts, which carry the tension. It’s the cheapest place to not cut corners.
- Gates. Walk gates, drive gates, or both. Gate count is one of the biggest single swing factors in a chain link bid, and a double drive gate with a drop rod adds real cost.
- Tension wire and top rail style. A tension wire bottom is a clean look with no bottom rail. A bottom rail keeps mesh from being pushed up. Pick based on whether you have dogs.
Where a brand helps, we lean on partners like Tamko and Boral for related exterior trim and posts on paired work, and PGT when a fence job sits next to window or door replacement on the same house.
What a Chain Link Fence Costs in Forest Hill, TX

Plan on $3,500 to $9,000 for a typical residential chain link fence in Forest Hill. Here’s what pushes a job to the low or high end.
- Linear footage. The single biggest driver. A small backyard run sits near the low number; a full perimeter on a larger lot pushes toward the top.
- Height and gauge. A 4-foot 11.5-gauge run costs meaningfully less than a 6-foot 9-gauge run of the same length.
- Gates. Each gate adds cost, and drive gates add more than walk gates.
- Demo and clearing. Removing an old fence, pulling concrete footings, and grinding stumps all add labor. Tight Forest Hill lots make this slower than open ground.
- Terrain and access. Sloped runs, narrow side yards, and staging constraints on 1950s plats add time. So does setting posts by hand where equipment can’t reach.
A written estimate from us lists footage, gauge, coating, post schedule, gate count, demo, and haul-off as separate lines. It does not include landscaping repair beyond basic raking, stump grinding unless you ask for it, or survey work to establish a property line. Upfront pricing, no surprises: the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Forest Hill Homes Specifically Do to This Job
Forest Hill is a small, fully built-out inner-ring suburb of Fort Worth, and that changes chain link work in ways it doesn’t in newer subdivisions. Almost nothing here is new construction. The housing stock is mostly small 1950s and 60s single-story ranch and minimal-traditional homes, many brick-veneer originals, sitting on a 1950s plat with narrow streets and mature trees. That means the real constraints on a chain link job are staging, haul-off, and root work, not design.
On these lots, equipment access is often the deciding factor. A crew that plans for a wheelbarrow and hand auger finishes cleanly; one that expects a machine to reach the back corner tears up a lawn or stalls. Expansive clay soils and the North Texas drought-to-flood cycle also heave posts over time, so we set footings deeper and check existing line grades before we start. If your property sits near Mansfield Highway, the utility locates and street parking plan get sorted before day one. Homeowners often pair a new fence with ADU Site Prep & Utilities in Forest Hill when they’re reworking the back lot anyway. For the wider project, see our Fence Installation in Forest Hill page, and step back to our Fence Installation service for the full picture. We cover all of Forest Hill, and if a gate replacement turns into a full exterior door swap, homeowners often pair this with Door Installation in Forest Hill.
Serving Forest Hill, TX – Our Local Coverage Area
We serve Forest Hill and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chain Link Fence in Forest Hill

Most chain link fence jobs in Forest Hill take one to three days once we’re on site, with larger perimeter jobs stretching to four or five days when there’s significant demo or stump work. Call (855) 912-5373 to schedule your free estimate and get a real timeline for your lot.
Fence permit requirements vary by height, location on the lot, and whether the fence sits on a property line, so it’s worth confirming before we order materials. We’ll walk you through what your specific project likely needs during the estimate, and pulling and passing inspections is part of how we run jobs. Call (855) 912-5373 and we’ll sort it out before the first post goes in.
Yes, in most cases, and on tight Forest Hill lots that’s exactly the plan. We hand-set posts where equipment can’t reach and route around mature trees rather than through them. Some lawn disturbance at each post is unavoidable. Call (855) 912-5373 for an on-site look at your access.
Chain link fence in Forest Hill typically runs $3,500 to $9,000 depending on footage, height, gauge, gate count, and demo. Call (855) 912-5373 for an exact quote. Estimates are free, and we put every line in writing.
Every chain link fence we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right, for two full years. Our technicians have up to 12 years of experience, and calls are answered by a live person around the clock. Call (855) 912-5373 with any question on the warranty, any time.
Get a Free Chain Link Fence Estimate in Forest Hill
Call (855) 912-5373 to schedule a free on-site estimate for your chain link fence in Forest Hill. We’ll walk the line with you, measure the actual run, count gates, and talk through gauge and coating options before anything is ordered. You’ll get a written, line-item quote with upfront pricing and no surprises, plus the 730-Day Done Right Promise behind the work. Estimates are free, and a live person answers the phone day or night.
Written by the team at Groundwork Construction Co.












