







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Haltom City, TX: What It Costs and How Fast It Goes In
A chain link fence in Haltom City runs $3,500 to $9,000 for a typical residential lot, and most jobs go from tear-out to tight lines in two to four working days. That range covers galvanized or vinyl-coated chain link at standard residential heights, set in concrete footings, with a walk gate or two. Call (855) 912-5373 for a free on-site estimate and a written line-item quote before anything gets dug.
How a Chain Link Fence Goes In: The Day-by-Day Sequence

Chain link is a fast install, but it’s not a slap-it-up job. The order of operations is what keeps the fence straight for the next twenty years, and on Haltom City’s clay it’s what keeps posts from heaving after a wet spring.
Day 1 – Walk and layout. We walk the property line with you, confirm the exact footage, and mark post locations. This is where you make the biggest decision: where the corners land and where the gates go. If the fence sits near a carport enclosure or a detached shop behind the house, we check clearances now rather than after the holes are dug. Utility locates get called before a spade touches dirt.
Day 1 or 2 – Demo and prep. Old fence comes out, posts and concrete and all. If there’s an existing fence line, we pull it and haul it off. If the grade steps or the yard slopes, we plan stepped panels so the bottom rail follows the ground instead of floating. You’ll decide here whether you want any brush cleared from the fence line.
Day 2 – Post setting. Holes get drilled or dug to depth and set in concrete. On the heavy clay through 76117, we set posts deeper and bell the footings so they grab below the active soil layer. Posts cure in place. This is the stage that can’t be rushed; a corner post set shallow will lean by the second summer.
Day 3 – Framing and fabric. Top rail, tension bands, and the chain link fabric get pulled and tensioned. Gates are hung and adjusted to swing true. You confirm the gate hardware – latches, hinges, whether you want a self-closer. Fabric gets stretched tight so there’s no sag at the gate posts.
Day 3 or 4 – Final walk. We tension-check every run, trim the post tops, and walk the line with you. Anything that’s off gets corrected before we call it done. Most jobs are finished in a single visit to the property for setting and a follow-up, and the whole thing is backed by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
- Gauge of the wire. Residential fabric typically runs 11.5 or 12.5 gauge. The heavier 11.5 gauge costs more per foot but resists denting from mowers and dogs far better. On a corner lot or a run along a driveway, it’s worth the difference.
- Galvanized vs. vinyl-coated. Bare galvanized is the value pick and holds up fine in North Texas. Vinyl-coated (black, green, or brown) runs a bit higher but blends into the yard and adds a layer of corrosion protection. Neither is a wrong answer; it comes down to what you want the fence to look like from the street.
- Height. 4-foot keeps dogs in and looks open. 5-foot is the common residential pick. 6-foot for privacy from a neighboring lot or to keep climbing dogs contained. Height moves the price noticeably because it changes fabric, posts, and rail.
- Posts and top rail. Standard is 1-5/8″ line posts with a 1-3/8″ top rail. Terminal posts at corners, ends, and gates get heavier pipe. Don’t cut corners on the terminal posts; that’s where fence failure starts.
- Gates. Walk gates in single or double configuration, sized to your mower and your access needs. Decide swing direction and whether you want a self-closing hinge. A wide double gate for a trailer or shop access costs more but is often the reason people are fencing at all.
If the fence is part of a larger push on the property, it pairs naturally with our Fence Installation service, and ADU Site Prep & Utilities in Haltom City often comes up when a homeowner is fencing off a future build site.
What a Chain Link Fence Costs in Haltom City, TX

Residential chain link in Haltom City lands between $3,500 and $9,000. That’s the honest range, and here’s what moves a job toward the low or high end:
- Linear footage. The single biggest driver. A small backyard run stays near the bottom; a full perimeter with frontage pushes toward the top.
- Height and gauge. 6-foot 11.5-gauge runs cost meaningfully more per foot than 4-foot galvanized.
- Gates. Each walk gate adds cost; double drive gates are a bigger line item.
- Demo and haul-off. Removing an old fence, posts, and concrete adds labor and disposal.
- Terrain and access. Stepped or sloped runs, tight side-yard access, and rock in the soil all add time.
A written estimate spells out footage, height, gauge, finish, number of gates, post spacing, concrete footings, and haul-off, so the number you see is the number you pay. What typically isn’t included: brush clearing beyond the fence line, moving buried utilities, or fixing a failing retaining wall the fence would sit on. Those get quoted separately after we’ve seen the site.
See the difference
Before
After
Before
After
Before
AfterWhat Haltom City Homes Do to This Job
Haltom City’s housing stock shapes fence work in ways that don’t show up on a spec sheet. The blocks through 76117 are mostly small 1950s to 1970s single-story ranches and bungalows, and a lot of them have accumulated decades of homeowner add-ons: carport enclosures, converted garages, lean-to shops out back. Fence lines that looked simple on a plat often run up against a structure someone built without a permit years ago, and that changes where posts can go. The expansive clay under these lots also moves with every wet-dry cycle, so post footings have to be set deep and belled or the fence wanders. And the industrial pockets along the NE 28th and Belknap corridor mean some fence lines back up to commercial lots, where you’ll want a taller, heavier run for privacy and security. We work all over Haltom City and know the ground we’re digging in.
Serving Haltom City, TX – Our Local Coverage Area
We serve Haltom City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Haltom City

Most residential chain link fences in Haltom City are complete in two to four working days, weather permitting. Post setting and curing is the stage that sets the pace, so a larger perimeter with multiple gates can push toward the far end of that window. Call (855) 912-5373 and we’ll give you a realistic timeline for your footage.
Most residential chain link fences in Haltom City don’t require a building permit, but corner lots and fences near the front setback line often have height and placement rules that apply. We check the specifics for your address during the estimate so you’re not caught off guard. Call (855) 912-5373 to confirm what applies to your lot.
Yes, in the vast majority of cases. We call for utility locates before digging, and post holes are typically the only digging involved; your plumbing, wiring, and existing structures stay put. Where a buried line conflicts with a post location, we adjust the spacing and tell you exactly why. Call (855) 912-5373 to talk through your layout.
A typical residential chain link fence in Haltom City runs $3,500 to $9,000 depending on footage, height, gauge, finish, and gates. A short backyard run with one walk gate sits near the bottom; a full perimeter with a double drive gate near the top. Call (855) 912-5373 for an exact quote; estimates are free.
Every chain link fence we install is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space, and it’s in writing. Call (855) 912-5373 to schedule your free estimate and see the terms.
Get a Free Chain Link Fence Estimate in Haltom City
Call (855) 912-5373 to schedule a free on-site estimate for your chain link fence in Haltom City. We’ll walk the line with you, measure the footage, talk through height, gauge, finish, and gates, and hand you a written line-item quote with upfront pricing and no surprises. If the fence is part of a bigger project, we can scope that too – homeowners often pair this with Door Installation in Haltom City or a full Fence Installation in Haltom City. Calls are answered by a live person, 24/7.
Written by the team at Groundwork Construction Co.












