







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Haltom City: What the Job Really Involves
Paver driveways in Haltom City typically run $7,000 to $18,000 for a standard two-car apron, and most jobs are finished in three to five working days once the base is set. You’re looking at excavation, a compacted aggregate base, edge restraint, and either clay or concrete pavers set on a sand bed. Call (855) 912-5373 and we’ll walk your drive and give you an exact number, free.
On the older blocks around 76117, the hardest part usually isn’t the pavers. It’s what’s already under the concrete you’re tearing out.
How We Build a Paver Driveway, Stage by Stage

Every project starts the same way: a walk-through where we measure the apron, check the slope back toward the street, and look for what the last sixty years left buried. Here’s what the schedule actually looks like.
Day 1 – Demo and haul-off. We break out the existing slab or gravel, load it, and haul it. On a typical Haltom City ranch lot that’s a single day for a two-car drive. This is the day the surprises show up. Old carport footings, a stray sewer cleanout, a gas line run shallow by a previous owner. You’ll know by end of day whether the number moves.
Day 2 – Excavation and grading. We cut down 8 to 10 inches to make room for base and pavers, then grade away from the house and the garage slab at roughly a 2% fall. On North Texas clay that grade matters more than the pavers themselves. Water that pools against a slab finds the foundation.
Day 2 to 3 – The base. This is the stage homeowners never see and the one that decides whether the driveway lasts 30 years or sags in five. We lay 4 to 6 inches of crushed limestone in lifts, then compact each lift. That’s where the labor goes. You decide nothing here except, if you want, to walk out and watch us compact. We encourage it.
Day 3 to 4 – Setting pavers and restraint. We set edge restraint along both sides, lay a sand bed, and set the pavers in the pattern you picked. Curves, herringbone, running bond, and border courses all get laid here. This is also where you decide whether the apron flares wider at the street for easier backing out.
Day 4 to 5 – Polymeric sand, cleanup, final walk. We sweep polymeric sand into the joints, mist it to set, and clean up. Then we walk the drive with you, mark anything that needs attention, and hand over the written paperwork on the 730-Day Done Right Promise. If it’s not right, we come back and make it right.
That’s the whole sequence on a straightforward job. Tight lots and add-on structures stretch it. If you’re part of a full Driveway & Pavers in Haltom City project that includes a patio or walkway in the same material, we schedule those in the same window so the crew and the sand don’t come back twice.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
You’ll pick three things: material, thickness, and pattern. Here’s the honest trade-off on each.
- Concrete pavers, 60mm. The standard choice for residential driveways. Color-stable, holds up to North Texas sun without fading the way some stamped concrete does, and if a paver cracks you swap one. Runs at the middle of the price range.
- Clay pavers. Warmer color, harder surface, and they hold their tone for decades. They also cost more and take a stonier joint tolerance. Suits a 1950s bungalow on a narrow lot where you want the look of age, not new-build shine.
- Thicker 80mm pavers. Worth the upcharge where a heavy truck parks or where the drive takes trailer traffic. On a standard ranch drive with two cars, 60mm is enough.
- Pattern and border. Running bond is the cheapest to lay. Herringbone costs a bit more in labor but locks pavers against shifting. A contrasting border course adds roughly a few hundred dollars and hides joint irregularities at the edges.
- Permeable joints. Polymeric sand is standard. In areas where water sheets off the drive toward a neighbor’s lot, a permeable open-graded joint is worth asking about.
We carry Belgard in the paver line, and the same eye for material quality we bring to Cabinets & Countertops in Haltom City work applies here. The pavers are the visible layer. The base under them is what you’re really buying.
What Paver Driveways Cost in Haltom City, TX

A paver driveway in Haltom City runs $7,000 to $18,000. The low end is a flat two-car apron on a lot with easy access. The high end is a long, curved drive with a wide street flare, extensive demo, or a sub-grade that needs reworking before anything goes down.
Here’s the line-item breakdown in a typical written estimate:
- Demo and haul-off of existing surface: $700 to $2,200
- Excavation and grading: $1,000 to $2,800
- Crushed limestone base, compacted in lifts: $1,500 to $3,500
- Edge restraint: $400 to $900
- Pavers, sand bed, and installation: $3,000 to $8,500
- Polymeric sand and final cleanup: $300 to $700
What moves the number most: drive length and width (a 400 sq ft apron versus an 800 sq ft drive doubles the material and the labor), existing surface (a clean concrete slab is easier to pull than a crumbled one with rebar), grade (a lot that falls toward the house needs extra fill and drainage work), paver grade (clay versus concrete, 60mm versus 80mm), and access (a narrow lot where the crew has to hand-carry pallets costs more than one where a truck backs straight in).
What’s included in our written line-item quote: demo, haul-off, base, restraint, pavers, polymeric sand, cleanup, and the 730-Day Done Right Promise in writing. What isn’t: any utility relocation if an existing line runs under the drive footprint, and any driveway apron permit fee the city requires. Both get flagged before work starts, never as a surprise invoice after. Upfront pricing, no surprises means exactly that. If you’ve been burned by a bid that grew after the first day of demo, you know why we say it.
See the difference
Before
After
Before
After
Before
AfterWhat Haltom City Homes Specifically Do to This Job
Haltom City was built by the families who worked the factories and warehouses around the Belknap and NE 28th corridor, and that shows up in the driveways. Most of the housing in 76117 is 1950s to 1970s single-story ranch and bungalow, and the lots are tight. That means two things for paver work: narrow aprons with little room to stage material, and a good chance the existing drive was a homeowner pour from 1978 with a carport slab poured nearby.
The bigger Haltom City factor is what sits on the slab. Expansive North Texas clay moves under these old drives, and a cracked, heaved apron is often the first sign the base under it has already failed. We see the same thing pulling up concrete we see on pier-and-beam floors in the same houses. If the ground moves, the surface can’t hold. On a paver drive the base is the fix, not a patch.
The other thing we run into on the older blocks: unpermitted add-ons built by earlier owners. Converted garages, lean-to shops, carport enclosures. When a paver driveway butts up against one of those, the apron has to be graded and edge-restrained to meet current city code even though the structure itself predates it. We pull the permits and pass the inspections, and if the existing structure has an issue that affects the drive, you hear about it before we lay a single paver.
We cover the whole of Haltom City, and we also work the nearby cities of Watauga, Richland Hills, and North Richland Hills. If you’re in the middle of a larger scope and need doors or openings adjusted to match a new drive, homeowners often pair this with Door Installation in Haltom City. More on our broader Driveway & Pavers work and our full Haltom City service area is on those pages.
Serving Haltom City, TX – Our Local Coverage Area
We serve Haltom City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Haltom City

Most paver driveways in Haltom City are finished in three to five working days once work starts. A flat two-car apron on a lot with easy access is the three-day end. Add demo of an old slab, a curve, or a long drive and you’re at five. Weather is the one variable we can’t schedule around, and a rain day after grading costs you a day. Call (855) 912-5373 and we’ll give you a firm start date and finish window in writing.
Yes, most paver driveway work in Haltom City requires a permit through the city’s building department, and we pull it for you. The permit covers the driveway apron where it meets the street and any change to the approach or drainage that touches the right of way. We handle the application and the inspection. You don’t chase paperwork. Call (855) 912-5373 and we’ll confirm what your specific address needs.
Not on our jobs. Paver driveways in Haltom City are quoted line-by-line with demo, base, pavers, and cleanup priced separately, so the number you sign is the number you pay. The only reason a number changes is if you approve a change mid-job, like adding a border course or widening the apron. If we find something under the existing slab that affects the scope, you hear it before we touch it. Call (855) 912-5373 for a written estimate, free.
Sometimes, but only when the existing slab is sound, level, and not heaving. On the older Haltom City stock we usually don’t recommend it. The clay moves, and pavers laid on a moving slab inherit the movement. A proper paver driveway needs a compacted aggregate base, and a thin overlay cuts the lifespan. We inspect the slab during the walk-through and tell you honestly which way makes sense. Call (855) 912-5373 and we’ll come out and check.
Every paver driveway we install carries the 730-Day Done Right Promise, and it’s in writing. That covers our workmanship for two full years. If a paver settles, an edge pushes out, or a joint opens, we come back and make it right. The manufacturer warranty on the pavers themselves passes through to you, and we’ll walk through both at handover. Call (855) 912-5373 and we’ll send the full terms before you commit to anything.
Get a Free Paver Driveway Estimate in Haltom City
If you’re ready to price a paver driveway in Haltom City, call (855) 912-5373 or request a free on-site estimate and design consult. A live person answers the phone around the clock. We come out, measure the drive, check the base conditions, and give you a written line-item quote with a firm price. No pressure on the call. Just real numbers so you can compare.
Written by the team at Groundwork Construction Co.












