







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Kennedale, TX: What the Job Actually Involves
Cabinets & countertops in Kennedale typically runs $14,000 to $45,000 for a full replacement, with cabinet installation alone at $4,000 to $13,000 and countertops at $2,000 to $6,500 depending on material. A straight cabinet-and-top swap takes two to four weeks from template to final caulk. The number that lands on your written estimate depends on box quality, stone grade, and whether the layout moves. Call (855) 912-5373 to schedule a free on-site estimate.
How We Run a Cabinet and Countertop Job, Stage by Stage

Every project follows the same five-stage sequence. What changes is the scope inside each stage, and that’s what we nail down at the estimate before anything gets ordered.
Stage 1: Measure and confirm the layout (day 1, about 2 hours)
We measure every wall, check for out-of-square corners, and photograph the plumbing and electrical runs behind the existing cabinets. This is where you decide whether the footprint stays or the sink and range move. Moving either one adds rough-in work and a permit line item, so we price both versions in writing before you commit.
Stage 2: Demo and prep (days 2 – 3)
Old cabinets and tops come out, and we check the wall behind them for water staining, soft drywall, or failed backer. In Kennedale’s older homes we regularly find moisture damage behind a sink that sat against an exterior wall, which means replacing drywall and sometimes a short stretch of plumbing before new boxes go in. You’ll approve any hidden-condition add before we proceed.
Stage 3: Cabinet install and countertop template (days 4 – 6)
Bases and uppers go in level and shimmed to the wall, then the sink cutout and appliance openings get finalized. The countertop fabricator templates from the installed cabinets, not from drawings, which is why the template comes after the boxes are set. Stone template to install runs seven to ten business days, and that’s the longest single wait in the project.
Stage 4: Countertop install and finish work (days 14 – 18)
Stone goes down, seams get epoxied and polished, and the sink, faucet, and disposal hook back up. Backsplash and any electrical trim-out close out the same window.
Stage 5: Walkthrough and punch list
We open and close every drawer, test every door for rub, check the seam alignment under raking light, and confirm the disposal and any new outlets work. Anything you flag goes on a punch list we close out before final payment, and all of it sits under the 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Cabinet and countertop decisions break into a handful of real forks. Here’s the honest trade-off on each.
- Stock vs. semi-custom boxes: Stock cabinets deliver in days and fit standard openings, but they leave dead space at odd wall lengths. Semi-custom (KraftMaid is what we specify most often) adds three to five weeks and roughly 20 – 35% to the cabinet line, and buys you real storage in a kitchen with a corner cabinet or an awkward run.
- Plywood vs. particleboard boxes: Plywood holds screws better through repeated door swings and survives a slow leak; particleboard is cheaper and fine in a dry, well-vented kitchen. In a home with a history of sink-area moisture, we push plywood.
- Quartz vs. granite: Quartz is non-porous and doesn’t need sealing, which matters in a busy household. Granite is more forgiving on heat and gives you a one-of-a-kind slab. Both land in a similar installed range at the mid tier; the difference shows up in edge profile and slab selection.
- Slab thickness and edge: Standard 3cm with an eased edge keeps cost down. A 2cm slab with a built-up edge reads thicker and costs more in labor, not material.
- Drawer and door hardware: Soft-close and full-extension slides are worth specifying at order time. Retrofitting them later means pulling every drawer box.
What Cabinets & Countertops Costs in Kennedale, TX

The full job runs $14,000 to $45,000. Cabinet installation alone is $4,000 to $13,000, countertop installation $2,000 to $6,500, a kitchen island $3,000 to $10,000, and backsplash $800 to $2,500 when you add one.
Five variables push a Kennedale job toward the low or high end:
- Linear footage and box count. A galley kitchen and a large open kitchen with an island are two different projects even with identical finishes.
- Existing condition. Water damage, out-of-square walls, or a floor that isn’t level force prep work you can’t see on day one.
- Layout changes. Relocating a sink, range, or dishwasher adds plumbing and electrical rough-in plus inspection.
- Material grade. Mid-tier quartz and semi-custom boxes sit in the middle of the range; a premium slab and full custom cabinetry push the top.
- Permit scope. A like-for-like swap may not trigger a permit; moving plumbing or adding circuits does.
A written estimate itemizes cabinets by box and finish, countertops by slab and square footage, install labor, demo, and disposal. It excludes anything behind the wall until demo confirms it. Upfront pricing means the number you see is the number you pay on the stated scope, with any hidden condition approved by you before it’s billed.
See the difference
Before
After
Before
After
Before
AfterWhat Kennedale Homes Do to This Job
Kennedale is small and largely built out, so most of this work is infill on existing lots rather than new construction, and the housing stock runs from older rural and mid-century homes on generous lots to newer custom builds. That mix changes what we find once the old cabinets come out: mid-century kitchens often have a narrower counter depth than modern appliances expect, and a wall that moved over sixty years of expansive clay shrink-swell can throw a run out of level by a half inch. On Kennedale’s larger lots, the kitchen often sits well back from the street, so a fabricator’s stone delivery and a cabinet truck both need a plan for the driveway approach. And because the city runs its own permitting and inspection rhythm inside 76060 rather than deferring to Tarrant County, we schedule around Kennedale’s submittal calendar instead of assuming a neighboring city’s timeline. This work is often the first phase of a larger Kitchen Remodeling in Kennedale project, and you can see the full scope through our Kitchen Remodeling service. We’re glad to be working across Kennedale, and many homeowners pair this with a Garage Conversion ADU in Kennedale or a New Detached ADU in Kennedale when they’re adding living space at the same time.
Serving Kennedale, TX – Our Local Coverage Area
We serve Kennedale and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Cabinets & Countertops in Kennedale

A straight swap takes two to four weeks from demo to walkthrough. The longest wait is the stone: template to install runs seven to ten business days, and semi-custom cabinets add three to five weeks to the front end. Call (855) 912-5373 for a timeline tied to your actual scope.
Usually not for a like-for-like swap, but moving a sink, range, or an electrical circuit does trigger a permit through the city. Because Kennedale runs its own permitting rather than deferring to the county, the submittal is specific to 76060. We handle that filing and the inspection so it doesn’t slow the install.
Yes, and that’s the most common scope we quote. Keeping the sink and range in place avoids rough-in work and keeps the project in the lower half of the $14,000 to $45,000 range. New doors, boxes, and stone transform a kitchen without touching the wall behind it.
Expect $14,000 to $45,000 for the full job, with cabinets at $4,000 to $13,000 and countertops at $2,000 to $6,500. A kitchen island adds $3,000 to $10,000 and a backsplash $800 to $2,500. Call (855) 912-5373 for a written line-item quote – the estimate is free.
Every cabinet and countertop install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right, for two full years. That covers workmanship on the install, door alignment, seam and caulk failure, and hardware. Manufacturer coverage on boxes and stone runs on top of it.
Get a Free Cabinet and Countertop Estimate in Kennedale
Call (855) 912-5373 to schedule a free on-site estimate for cabinets and countertops in Kennedale. A live person answers around the clock, and we’ll walk your kitchen, measure, and talk through box grade and stone options before any number goes on paper. You leave the visit with a written line-item estimate, permits and inspections explained, and the 730-Day Done Right Promise in writing.
Written by the team at Groundwork Construction Co.












