







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Driveway & Pavers in Fort Worth: What to Know First
We install, repair, and replace Belgard paver driveways, patios, and walkways across Fort Worth as an independent Belgard service provider. Most residential paver driveways run two to four days from base prep to final sealer, and a patio or walkway typically lands in one to three. Our pricing is upfront: a written line-item number before we break ground, and that number is what you pay. Belgard paver driveway installation in Fort Worth runs $7,000 – $18,000 for most homes, driven by square footage, base depth, and which Belgard line you choose. This page is for homeowners with an existing Belgard surface to fix or a specific Belgard product they’ve picked out for a new one. Call (855) 912-5373 and a live person answers, any hour.
How Belgard Products Fail – and How We Fix Them
Belgard pavers are strong product. What fails around here is almost never the paver itself – it’s the base, the joint sand, the edge restraint, or the sealer, and each shows up in Fort Worth differently than it would in a drier market. Here’s what our crews actually see:
- Base failure under the driveway apron, not the field. The spot where the city sidewalk meets your drive takes the most water and the most turning-load from vehicles. On Belgard Urbana Stone and Catalina installs, we routinely find the aggregate base compacted to 4 inches at the apron when it needs 6 to 8 with a geotextile underneath. The symptom is a shallow dish that holds water after every rain. Our fix is to pull the affected field, re-excavate to full depth, compact in lifts, and reset with fresh edge restraint – not to skim over the low spot with sand.
- Joint sand washing out of the open-graded lines. Belgard Mega-Arbel and similar large-format pavers have wider joints than a standard 60mm unit. In our spring storms that sand goes quickly, and once joints hollow out, the pavers start to rock and chip at the corners. We re-sweep with a polymeric joint sand rated for the joint width and vibrate it into place, then top it again after settling.
- Efflorescence on Belgard Holland Stone and other dense concrete pavers. That white haze is mineral salt migrating to the surface, and in Fort Worth’s humid spring it shows up on newer installs within months. It’s cosmetic, not structural. We test before treating, apply a mild efflorescence cleaner, and let the slab dry fully before any sealer goes down – sealing a wet paver locks the salt in and makes it worse.
- Edge restraint separation on curved driveways. Belgard Bristol and Ashlar blends get used a lot on curved approaches here, and if the plastic edge restraint wasn’t spiked deep enough into our expansive clay, the whole field walks outward over two or three summers. We reset the restraint with longer spikes and re-pack the shoulder, which stops the creep before it turns into a full re-lay.
- Sealer failure and the gray-out. Cheap film-forming sealers trap moisture and turn cloudy or flake within a year on Fort Worth pavers. We strip the old coating, clean and dry, then apply a breathable penetrating sealer that darkens the color without a plastic sheen and lets the slab dry from below.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Our Belgard Driveway & Pavers Process
- 1
On-site walkthrough. We look at the base, the slope, the drainage path, and the edge restraint, and we ask what Belgard line your existing surface is and when it went in. You get a free estimate and design consult at the same visit.
- 2
Written line-item quote. Square footage, base depth, restraint, joint sand, sealer, haul-off, and any Belgard product selection are priced separately so you can see exactly where the money goes. Upfront pricing, no surprises.
- 3
Material and product decision. If you’re repairing, we spec genuine Belgard units to match your series and color where they’re still in production, or a close current match where they aren’t – and we tell you honestly when an aftermarket match is the smarter buy.
- 4
Base prep done right. Excavate, grade for drainage away from the slab, lay geotextile where the subgrade demands it, and compact in lifts. This is the part nobody sees and the part that decides how long the surface lasts.
- 5
Install, then verify. Set the pavers, cut edges, spike the restraint, sweep and vibrate joint sand, and check the finished plane with a straightedge for ponding before we call it done. Most jobs finish in a single visit to the site.
- 6
Cleanup and the 730-Day Done Right Promise. We haul off spoil, wash the surface, and hand you a written workmanship guarantee. If it’s not done right, we make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Belgard Driveway & Pavers Costs in Fort Worth

These are the ranges we quote for Belgard work in Fort Worth, and they reflect what local material and labor actually cost rather than a national average:
- Belgard paver driveway installation: $7,000 – $18,000
- Brick paver driveway: falls within the same paver range, higher at the top end for tumbled or hand-set patterns
- Concrete driveway installation (as an alternative): $4,500 – $12,000
- Concrete driveway replacement: $5,000 – $14,000
- Asphalt driveway paving: $3,500 – $9,000
- Belgard paver patio installation: $3,500 – $11,000
- Driveway sealing: $250 – $700
What moves a Belgard price: base depth (our clay subgrade often calls for more excavation and aggregate than a drier market), the paver series and pattern, square footage, drainage fixes, and whether we’re tearing out an old surface. A written line-item estimate keeps that all visible up front, and your number doesn’t change once work starts. Call (855) 912-5373 to schedule your free estimate.
Why Fort Worth Homeowners Call Groundwork Construction Co. of Fort Worth for Belgard Work
Belgard is a strong paver, but a paver is only as good as the base under it and the crew setting it. That’s where we stand apart. Every Belgard project we install or repair is covered by our 730-Day Done Right Promise – one of the longest workmanship guarantees in residential construction – and it’s backed in writing, not in a brochure. Our technicians have up to 12 years of experience and arrive background-checked and in uniform, and your calls are answered by a live person around the clock, not a voicemail box. Paver work is one of our seven core service lines, and we bring the same brand discipline to it that we do elsewhere – KraftMaid and Kohler in kitchens and baths, GAF roofing, PGT and Andersen windows. One contractor, from foundation to finish line. Call (855) 912-5373 and we’ll put a real number in front of you.
FAQs

Belgard’s product warranty covers the paver material itself and generally survives repair or re-install by a qualified contractor, but any workmanship warranty from your original installer likely doesn’t transfer – which is why we back our installation with our own 730-Day Done Right Promise. Call (855) 912-5373 for a free estimate and we’ll walk you through what’s covered.
Usually, yes – Belgard keeps many long-running lines like Holland Stone and Catalina in production, and we source genuine matching units where we can. For discontinued or limited-run series, we tell you honestly when a close current match or an aftermarket unit is the practical choice. Call (855) 912-5373 to schedule your free estimate and we’ll verify your match on site.
Repair if the base is sound and the failure is isolated to joints, edge restraint, efflorescence, or sealer – that’s often $250 – $700 for a reseal or a few hundred more for a spot re-lay. Replace when the base has failed across a large area or the pavers have walked apart over years. We’ll tell you which one you actually need at the free estimate. Call (855) 912-5373.
Most residential Belgard paver driveways take two to four days from base prep to sealed finish, and a patio or walkway lands in one to three. Weather and drainage fixes push that a bit. Call (855) 912-5373 and we’ll give you a realistic timeline with your written quote.
No. Our upfront pricing means the number on your written line-item quote is the number you pay – no surprise change orders, no “we found something.” If we discover a genuine issue in the base, we stop and walk you through it before touching anything. Call (855) 912-5373 to schedule your free estimate.
We do Belgard paver patios, walkways, and pool decks alongside driveways, and the same workmanship guarantee applies to all of it. Call (855) 912-5373 for a free estimate and design consult.
Belgard is one of our trusted brand partners, and paver driveway and patio work is one of our seven core service lines in Fort Worth. Whether you’re repairing a worn Belgard surface, resealing, or starting a new paver driveway from scratch, you get upfront pricing, background-checked and uniformed technicians, and a live person on the phone any hour. Mention the $1,000 off projects over $10,000 and 0% financing for 18 months while you’re at it – both available on qualifying work. Call Groundwork Construction Co. of Fort Worth at (855) 912-5373 to schedule your free estimate and design consult.
Written by the team at Groundwork Construction Co. of Fort Worth, serving Fort Worth and nearby areas.












